Menu
Tire Finder Dealer Locator

5 Year Limited Warranty

This Standard Limited Warranty Policy and Procedures (“Standard Limited Warranty”) applies to all new Consumer tires (PCR/LTR) purchased on or after January 1, 2024, sold or distributed under the GT Radial brand bearing the corresponding D.O.T. tire identification number.


To be eligible, the following criteria must be met:

  • Purchased in the United States or Canada;
  • The tires were operated under normal service conditions and used on the same vehicle on which they were originally installed and according to the vehicle manufacturer’s recommendations;
  • The consumer is the original purchaser of the tire.
  • The tires are of correct size, load and speed rating for the make and type of vehicle;
  • The tires were used on the proper road surfaces for which they were designed;
  • The tires are not subject to an exclusion (see “What is not covered by the Standard Limited Warranty”).
  • The warranty claim procedure found under “Owners obligation”, is completed in full.

What is not covered by the Standard Limited Warranty

  • Purchased or used outside the United States or Canada;
  • Incorrect size or load rating for the vehicle;
  • Road hazard injury (e.g., a cut, snag, bruise, impact damage or puncture). For selected products covered by the Road Hazard Warranty;
  • Improper use or operation, including improper inflation pressure, overloading, curbing, use of improper rim or wheel, improper mounting or demounting, tire/wheel spinning, misuse, misapplication, negligence, tire alteration, or use in competition or racing
  • Use in commercial applications for tread wear
  • Improper maintenance of tire, wheel, or vehicle components: misalignment, imbalance, worn components, or other vehicle conditions, characteristics or defects;
  • Highway tires that are operated in on-off highway applications;
  • Tires subjected to severe under-inflated or run-flat conditions;
  • Improperly repaired tire;
  • Uneven or rapid wear which is caused by mechanical irregularity in the vehicle such as wheel misalignment, (measured tread difference of 2/32 inch or more across the tread on the same tire);
  • Accident, fire, chemical corrosion, or vandalism;
  • Flat spotting caused by improper storage or brake lock;
  • Contamination or degradation by petroleum products or other chemicals, solid or gaseous materials other than air, nitrogen or carbon dioxide (for example, water-based sealers or balancing substances);
  • Ozone or weather cracking after 48 months from manufacturing date;
  • With the serial number buffed, cut or illegible;
  • With less than 2/32nds of an inch remaining tread in any groove;
  • With a ride disturbance complaint that occurs after the first 2/32nds of tread wear;
  • Damaged through use of any tube or flap;
  • Damaged through improper use of tire chains;
  • Use of Run Flat technology tires without a properly operating low air pressure warning system (TPMS – Tire Pressure Monitoring System).
Vehicle
Size
Close

Search by vehicle or tire size.

What type of fitment do you have?

Search by vehicle:

Year
Make
Model
Trim

Search by size:

Section Width Section Width How to find your width? This three-digit number represents the width of the tire in millimeters (mm), measured from sidewall to sidewall. Since this measure is affected by the width of the rim, the measurement is done when the tire is on its intended rim size.
Aspect Ratio Aspect Ratio How to find your aspect ratio? The aspect ratio is the relationship of a tire's sidewall height to its section width, expressed as a percentage. In this example, the tire sidewall height is approximately 55% of the tire width. The higher the number, the taller the sidewall; the lower the number, the shorter the sidewall.
Rim Diameter Rim Diameter How to find your Rim Diameter? The diameter of the rim in inches.

                  © GT Radial. All Rights Reserved.